https://boards.hellobee.com/ Pregnancy, Baby and Parenting blog, by Hellobee en Sun, 17 May 2026 03:21:51 +0000 https://boards.hellobee.com/topic/britax-pavillion#post-1253132 Mon, 02 Dec 2013 09:42:36 +0000 jodyblair 1253132@https://boards.hellobee.com/ <p>@butterbean: Thanks! With some trial and error, I have found that if I put my fingers between the grey rubber pieces (hug straps?) and the chest clip and pull out, it loosens up much easier, instead of pulling from underneath the rubber part. I'm not sure if this is how it's supposed to be done, but it seems to work. </p> https://boards.hellobee.com/topic/britax-pavillion#post-1253112 Mon, 02 Dec 2013 09:34:57 +0000 butterbean 1253112@https://boards.hellobee.com/ <p>@jodyblair: hi! i went back and pulled on all the straps and somehow something must have loosened up because now it's a bit easier to loosen/tighten the harness...sorry this may not be as helpful as you hoped! </p> https://boards.hellobee.com/topic/britax-pavillion#post-1247483 Wed, 27 Nov 2013 13:19:52 +0000 jodyblair 1247483@https://boards.hellobee.com/ <p>@butterbean: Did you figure out a solution? We just bought a pavillion and I'm having the same issue. </p> https://boards.hellobee.com/topic/britax-pavillion#post-1187328 Thu, 31 Oct 2013 08:09:45 +0000 butterbean 1187328@https://boards.hellobee.com/ <p>@Thenetexan: hmmmm....i'll have DH look at how the carseat was installed..</p> <p>@mediagirl: thanks!!! </p> https://boards.hellobee.com/topic/britax-pavillion#post-1187298 Thu, 31 Oct 2013 07:58:46 +0000 mediagirl 1187298@https://boards.hellobee.com/ <p>We had a hard time with this, too. You have to keep the clips clasped together until you have loosened it. Make sure you are pulling up on the little latch in the bottom of the seat and then pull the clips at the same time. It took me a while to get used to it... </p> https://boards.hellobee.com/topic/britax-pavillion#post-1187291 Thu, 31 Oct 2013 07:57:41 +0000 Thenetexan 1187291@https://boards.hellobee.com/ <p>@butterbean: we had the same issue when we first transitioned. Our initial problem was that when we installed it, the end of the belt that should just stick out the bottom by the feet was looped and trapped. Random and I doubt that happened to you too. If you can touch the end, that is not your issue. That said, it does not loosen as much in comparison to the Chicco keyfit. So, it may just take awhile for you to get used to it. </p> https://boards.hellobee.com/topic/britax-pavillion#post-1187166 Thu, 31 Oct 2013 07:10:43 +0000 butterbean 1187166@https://boards.hellobee.com/ <p>@chopsuey: thanks for bumping!! :happy: </p> <p>@jmarionsmith: yes it does...that's what i thought we were doing...will try it again today... </p> https://boards.hellobee.com/topic/britax-pavillion#post-1185939 Wed, 30 Oct 2013 17:37:53 +0000 jmarionsmith 1185939@https://boards.hellobee.com/ <p>pull on the chest clip with one hand and lift up the "lever" that allows it to loosen with your other hand.</p> <p>does that make sense? </p> https://boards.hellobee.com/topic/britax-pavillion#post-1185894 Wed, 30 Oct 2013 17:22:57 +0000 chopsuey 1185894@https://boards.hellobee.com/ <p>@butterbean: bumping for you! </p> https://boards.hellobee.com/topic/britax-pavillion#post-1179067 Mon, 28 Oct 2013 12:27:34 +0000 butterbean 1179067@https://boards.hellobee.com/ <p>if you have the britax pavillion carseat, how do you loosen the harness? we seem to be following the instructions but we feel like it's not really loosening up...</p> <p>i'm used to loosening/tighting the harnesses on the chicco keyfit 30 infant carseat so i thought it would be the same on the britax...</p> <p>i guess not? </p>